Tcp/Ip Parameter Configuration - Agilent Technologies 1100 Series User Manual

TCP/IP parameter configuration

To operate properly in a network environment, the LAN interface must be
configured with valid TCP/IP network parameters. These parameters are:
• IP address
• Subnet Mask
• Default Gateway
The TCP/IP parameters can be configured by the following methods:
• by automatically requesting the parameters from a network-based BOOTP
• by manually setting the parameters using Telnet
• by manually setting the parameters using the Handheld Controller
The LAN interface differentiates between several initialization modes. The
initialization mode (short form 'init mode') defines how to determine the
active TCP/IP parameters after power-on. The parameters may be derived
from a Bootp cycle, non-volatile memory or initialized with known default
values. The initialization mode is selected by the configuration switch, see
Figure 7
1100 Series DAD and MWD User Manual
Server (using the so-called Bootstrap Protocol)
(G1323B)
on page 34.
LAN Configuration
33
3