Table of Contents
Advertisement
* In order to use P606 you will need to install the inchided USB
driver in your computer. Refer to "Installing the USB Driver"
(p. 83).
* For details on how to use P606, refer to P606 Help.
* P606 will not start up unless the SP-606 is connected to your
computer using USB,
Installing P606
Run the program setup.exe from the included "P606" CD-
ROM. Install P606 as directed by the instructions that appear
on your screen.
Controlling P606 from the
SP-606
When using the SP-606 together with P606, you can set the SP-
606 to External mode so the P606 can be controlled from the
SP-606 (p. 15).
Before You Control P606 from the SP-606
1.
Using USB, connect the SP-606 to your
computer (p. 83).
2. Start up P606.
3. On the SP-606, press [EXT] so it's lit.
The screen will indicate "EXT Control."
List of Control Functions
Pads [1]}-[16]
By holding down [FUNC] and pressing pads [1], [2], [3], [5], or
[6], you can select the function that the pads will subsequently
perform.
* Hold down [FUNC] and press pad [1] (PART SEL)
Pads [1]-[16] will directly select the identically numbered
part within P606.
Chapter 14. About P606
* Hold down [FUNC]
and press pad [2] (MUTE)
Pads [1]-{16] will directly switch Mute on/off for the
identically numbered part within P606.
¢ Hold down [FUNC]
and press pad [3] (SOLO)
Pads [1]-[16] will directly switch Solo on/off for the
identically numbered part within P606.
Hold down [FUNC]
and press pad [5] (NOTE TRIG)
Pads [1]~[16] will transmit note messages to P606; you
can use the pads to play the current part within P606.
Hold down [FUNC] and press pad [6] (SEQ TRIG)
Pads [1]-[16] will switch to the identically numbered
current sequence within P606.
Cursor
[ « ][ - ][ «][> ]
These buttons move the cursor within the "PART MIXER" of
P06.
* [ <] (Left) /[ » ] (Right)
Press these buttons to move the cursor between parts.
© [ «4 } (Up) /[ ¥ ] (Down)
Press these buttons to move the cursor between SELECT,
MUTE, SOLO, PAN, and LEVEL.
VALUE dial, [DEC][INC]
These edit the value (MUTE, SOLO, PAN, LEVEL) at the
cursor location.
[ENTER]
When the cursor is located at MUTE or SOLO, this button
switches the setting on/off.
These buttons correspond to the "TRANSPORT" buttons in
P606.
CTRL 1-3 knobs, D Beam controller
These correspond to P606's "ASSIGNABLE CONTROLS"
settings for the CTRL 1-3 knobs and
D BEAM.
Advertisement
Table of Contents
