Table of Contents
Advertisement
Top, Front, and Rear Panels
Rear Panel
CE. Gus FE
1. Cord hook
Use this to fasten the AC adaptor cable (p. 20)
2. Ground terminal
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it, or the
metal portions of other objects. This is due to an
infinitesimal electrical charge, which is absolutely
harmless. However, if you are concerned about this,
connect the ground terminal (see figure) with an external
ground. When the unit is grounded, a slight hum may
occur, depending on the particulars of your installation.
If you are unsure of the connection method, contact the
nearest Roland Service Center, or an authorized Roland
distributor, as listed on the "Information" page.
Unsuitable places for connection
* Water pipes (may result in shock or electrocution)
¢ Gas pipes (may result in fire or explosion)
* Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
3. POWER switch
This turns the power on/off. (p. 21)
4. AC adaptor jack
Connect the included AC adaptor here. (p. 20)
5. USB connector
Use a USB cable to connect the SP-606 to your computer.
(p. 83)
_ Roland
AL rary
ssi ET
Foot,
SNITCH,
6. MIDI connectors (OUT/IN)
Use these to connect MIDI equipment. (p. 78)
7. DIGITAL jacks (OUT/IN)
Connect your audio source to the IN jack if you want to
sample via the digital input. Connect to the OUT jack if
you want to use digital output. (p. 20)
8, FOOT SWITCH jack
You can connect a foot switch (DP-2, BOSS FS-5U; sold
separately) to this jack. (p. 20)
9. INPUT jacks
Connect your audio source or microphone to this jack if
you want to sample via the analog input. If you're
inputting a monaural source, connect it to the L (MONO)
jack. (p. 20)
10. OUTPUT jacks
These are analog output jacks. If you're outputting in
monaural, use the L (MONO) jack. (p. 20)
11. PHONES jack
Connect a set of stereo headphones to this jack. Even if
headphones are connected, sound will still be output
from the DIGITAL OUT and OUTPUT jacks. (p. 20)
12. Security slot cf
http://www.kensington.com /
19
Advertisement
Table of Contents
