Table of Contents
Advertisement
Chapter 3. Sampling
Resampling (Automatic)
Here's how up to four existing samples can be layered and recorded (resampled) as a single sample.
1.
Go to the Play screen (p. 15).
2.
Press [SAMPLING] to get the SAMPLING MENU screen.
[SAMPLING] will blink.
3.
Press [F2] (RESMPL) to get the RESAMPLING STANDBY screen.
In the lower line of the screen, REMAIN indicates the length (remaining time) available for
resampling. This time will change depending on the Stereo Sw (p. 46) and Sampling Grade (p. 43)
setting. It is shown in minutes and seconds.
From the screen of step 3, you can press [ w ] to move the cursor to "Resampling" and then press
[ENTER] or [SAMPLING] to obtain the same result.
If the selected pad already contains a sample, the message "A Sample Already Exists! Overwrite?"
will appear. If you are sure you want to resample into that pad, press [F3] (EXEC). If you decide to
cancel, press [F2] (CANCEL).
Rea
Resampling can be performed only within the same pad bank. You cannot resample within a pad
bank that contains no samples. If you press a pad in an empty pad bank, the screen will indicate
"Empty Pad Bank," and the pad cannot be selected.
TIP:
Press [F2] (FromTo) to toggle between selection of the
resampling source and destination pads. This changes the item to which the [PAD SELECT] arrow
in the screen is pointing. The upper line is the resampling-destination pad, and the lower line is the
resampling-source pad.
6.
Use[ w ][ « ][ < ][ > ] to select the parameter you want to edit.
Turn the VALUE dial or use [DEC][INC] to edit the value of the parameter.
Parameter
'a Value
Explanation
a
Velo
| 1-127
7
Specifies the volume of the sample in the resampling-source pad.
Stereo Sw
STEREO,
Selects stereo or monaural recording.
MONO(L+R),
STEREO: Stereo recording.
MONO(L)
MONO(L+R): The left and right channels of the stereo sample will be mixed,
|
and recorded in monaural.
MONO(L): Monaural recording.
Auto Trig
OFF,
This setting causes resampling to start automatically when the audio signal
1-14
from the source sample(s) exceeds the level you specify.
OFF: The level is not specified.
1-14: Resampling wil] start automatically when the source signal exceeds
|
the specified level. Level 1 is the lowest.
|
7.
Press [F3] (START) or [SAMPLING] to begin resampling automatically.
If you decide to cancel the resampling procedure, press [EXIT].
ee
46
Advertisement
Table of Contents
