Table of Contents
Advertisement
About the System Settings
80
9.
10. Press [F1] (PRESET) to add a check mark to "Load Factory Data"
The included "DRIVER/FACTORY DATA" CD-ROM contains data you can use to restore the SP-606 to the state
it was in when it left the factory.
Ces
All internal memory data will be lost if you perform this procedure. If you want to keep vour data,
make a backup before you proceed. (Backup Save -> p. 70)
You will need the following items.
*
Acomputer with a CD-ROM drive
¢
An appropriate card reader for the memory card
¢
The included "DRIVER/FACTORY
DATA" CD-ROM
*
Amemory card (formatted on the SP-606)
Refer to "Formatting (Initializing) a Memory Card" (p. 67).
Connect the card reader to your computer, and make it ready for use.
manuals.
Insert the included "DRIVER/FACTORY DATA" CD-ROM
into your CD-ROM
drive.
Insert the memory card into the card reader.
Copy the "FCTRY" folder from the included "DRIVER/FACTORY DATA" CD-ROM into the "ROLAND"
folder of the memory card.
NOTE
If the "ROLAND"
folder of the memory card already contains a "FCTRY" folder, delete this
"FCTRY" folder from the card before copying from the CD-ROM.
Remove the memory card from the card reader, and insert it into the SP-606's card slot.
Go to the SP-606's Play screen (p. 15).
Press [MENU] to get the Top Menu screen.
Move the cursor to the "1:SYSTEM" line, and press [ENTER].
The SYSTEM screen will appear.
Press [F3] (INT) to get the SYSTEM INITIALIZE screen.
| NOTE | Ifa memory card is not inserted, the display will indicate
"Card Not Ready!"
p- 58), the message "Protected" will appear, and the Initialize operation cannot be executed.
11. Press [F3] (EXEC).
If you decide to cancel, press [F2] (CANCEL).
Advertisement
Table of Contents
