Audio Dubbing Using The External Or Built-In Microphone - Panasonic Digital Palmcorder PalmSight PV-DV600 Operating Instructions Manual

Special Features
Audio Dubbing using the
External or Built-in Microphone
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone or an external microphone.
Externa! Microphone
with M3 connector
(not supplied)
External
Microphone Jack
A.DUB
Button
Before you begin...
* Connect the external Microphone (if used).
* Turn On the Palmcorder.
* Insert a pre-recorded tape to be dubbed.
The AUDIO-REC setting in CAMERA MENU
mode should be as follows:
12 bit The original sound is recorded on ST
(Stereo) 1, and the new sound will be
recorded on ST (Stereo) 2.
16bit The original sound is replaced with
the new sound.
* Select 12 bit if you do not want the original
sound to be completely replaced during an
audio dub.
* [f you dub over a tape which has both 12
bit and 16bit audio recordings on it, keep
in mind that the original 16bit audio portion
will be completely replaced.
1 Set POWER to VCR.
s The POWER lamp lights red.
* Be sure POWER is fully turned to
VCR position.
2 Press PLAY.
Then press PAUSE where you want
dubbing to begin.
3 Press A.DUB on this unit (for three
seconds) or the remote control
(optional, page 74) to put the
Palmcorder in the Audio Dub mode.
e "A.DUB" flashes in the EVF or the
LCD monitor.
EVF/LCD Indication
(Continued on next page.)
59
o»
O
(D
2.
=
TI
©
e
mr
c
-—-
T
0