So A Ani - Panasonic Digital Palmcorder PalmSight PV-DV600 Operating Instructions Manual

Card PhotoShot
You can record still images to a
MultiMediaCard.
PHOTOSHOT
JOG KEY
TAPE/M-CARD POWER Switch
Switch
image Resolution and Capacity
(8MB MultiMediaCard)
Image
¢ The number of images given for each
mode applies when all images are taken
in same mode.
* You can change recording modes at any
time before capturing an image.
* The number of images that can be
captured may differ depending on the
subject. After capturing an image, the
number may not decrease, or it may
decrease by two. This is normal.
* While "PROCESSING" is displayed, do
not turn off the Digital Video Camera or
unplug the AC Adaptor (supplied)
because this will cause irreversible
damage to the memory.
REC
Mode _ | Resolution Capacity
FINE 640 x 480 | Approx. 60 images
NORMAL | 320 x 240 | Approx. 240 image
Before you begin...
* Connect the Palmcorder to a power source
(pages 12, 13).
* Set POWER to OFF before inserting a
MultiMediaCard ( page 9).
1 Set POWER to CAMERA.
* The POWER lamp lights red.
* Be sure POWER is fully turned to
CAMERA position.
2 Set TAPE/M-CARD to M-CARD.
(page 9).
* "PLAY: PUSH PLAY KEY" is
displayed for 10 seconds (page 43).
PLAY: PUSH PLAY KEY
3 Press MENU to display CARD
SETTING menu, then press JOG KEY
to select NORMAL or FINE.
CARD SETTING
REC MODE
eib
NORMAL FINE
*SET : PUSH JOG KEY
'EXIT :PUSH MENU KEY
* Press MENU to exit this menu.
so
4 Press PHOTOSHOT to record an
image.
PHOTO
12:34:58AH
JAN 2 290
12:34:586AM
0 9 JAN 2 2000
* The PhotoShot image is recorded to
the MultiMediaCard.
* When SHUTTER is set to ON (page
23), still pictures are recorded with a
visual shutter effect and click sound. if
set to OFF, only the visual shutter
effect will occur.
41