Audi Q5 2016 Owner's Manual page 51

.....
N
co
~
CX)
.....
I.Cl
U"I
.....
I.Cl
.....
Operation
Applies to vehicles: with garage door opener (Homelink)
Fig. 44 Headliner: contro l unit
Requiremen t: The buttons in the roof headliner
must be programmed
c:>
page 49 or
c::>
page 50 and the vehicle must be within
range of the system, such as the garage door
opener.
" Press the button to open the garage door . The
LED@ blinks or turns on .
" Press the button again to close the garage
door .
@
Tips
To open or close the garage door, press the
button, but do not hold it for longer than
10 seconds or the garage door opener module
will switch to programming mode.
Programming the buttons (version A)
Applies to vehicles: with garage door opener (Homelink)
You can program both fixed code and rolling code
systems using this procedure.
Programming or reprogramming buttons
"Switch the ignition on .
"Press and hold the button in the roof headliner
c::>
page 49, fig. 44 that you would like to pro-
gram for at least 10 seconds. Or
.. Select:
I CAR I
function button > Car systems*
control button > Vehicle settings > Garage
door opener> Program garage door opener. If
this path is not available, program the button
as described in version B
c::>
page 50 .
"Follow the instructions in the MMI* .
Opening and closing
Erasing button programming
The programmed buttons cannot be erased indi-
vidually. They must all be erased together. Re-
program the buttons if necessary.
"Select:
!CAR !
function button> Car systems*
control button > Vehicle settings > Garage
door opener> Clear program settings > Yes.
Displaying the version/status/country code
"Select:
!CAR !
function button> Car systems*
control button
>
Vehicle settings > Garage
door opener> Version information.
(D
Tips
- Programming through the MMI* is not pos-
sible with all infotainment systems. If this
is the case, program the buttons as descri-
bed in version B
c::>
page 50.
- The required distance between the hand
transmitter and the Homelink module in
the radiator grille
c::>
page
50,
fig.
45 de-
pends on the system that you are program-
ming.
- Depending on the model of the system, you
may need to release the button on the re-
mote control during programming and
press it again. Hold each position you try for
at least 15 seconds before trying another
position . Keep the turn signals on your vehi -
cle in view when doing this .
- After programming the garage door opener,
it may be necessary to synchronize the mo-
tor with the system. Refer to the manufac-
turer's instructions.
49