A Note symbol also contains special and additional notes ♦ on repair measures and associated information. Audi AG will not accept responsibility in the event of failure to comply with these assembly instructions. Special information about using the partition grid...
Page 4
Audi Q5 2009 No. 66, Body, Edition 11.08 – To open, move the backrest forwards (⇒ vehicle owners manual) and loosen both of the star grip screws on the load-through hatch. – Open the load-through hatch. – After pushing the rear seat backrest back, ensure that the partition grid is not touching the backrest.
Audi Q5 2009 No. 66, Body, Edition 11.08 Parts overview of space separator Space separator assembly set -8R0 017 222- Comprising: 11 - Space separator 12 - Star grip screw (small head - 2x) 13 - Star grip screw (large head - 1x)
Audi Q5 2009 No. 66, Body, Edition 11.08 Partition grid assembly set Note The luggage compartment cover and net partition cannot be used when the partition grid is installed. – Check that the assembly set is complete. – Remove the net partition (if present).
Page 8
Audi Q5 2009 No. 66, Body, Edition 11.08 – Screw the partition grid -1- and the upper brackets -9- together loosely using the star grip screws (small head) -2-. ZUB-0099 Vehicles without a rack system for loading safety (fixed fastening rings) –...
Page 9
Audi Q5 2009 No. 66, Body, Edition 11.08 – Insert the respective counterhold bracket into the opening in the rails and push forward -Arrow-. ZUB-0103 – Bring the bracket -4- into the installation position and screw onto the partition grid -1- with the star grip screws (small head) -2-.
Audi Q5 2009 No. 66, Body, Edition 11.08 Space separator assembly set – Insert the support plates -14- from below in the drill holes -A- on the space separator -11-. ZUB-0106 – Position the space separator either in the middle or create a 1/3 and a 2/3 section.