Table of Contents
Advertisement
Hybrid
@
Tips
The Energy flow display will not shown in the
MMI display when the reverse gear is engag-
ed, due to safety reasons.
Consumption display
App lies to vehicles: with hybrid drive
Fig. 114 MMI display: consum pt ion display
The consumption display shows the average en -
ergy consumption and the recuperation quantity
in 5 minute intervals .
Calling up the consumption display
• Select :
I
MENU
I
function button>
Hybrid
control
button .
• Turn the control knob counter -clockwise.
Resetting the consumption display
• Select :
I
MENU
I
function button >
Hybrid
control
button.
• Turn the control knob to
Reset consumption
statistics.
The orange bars show the average consumption
and the green bars show the recuperation quanti-
ty. Each bar represents a measured 5 minute in-
terval. The display covers a 60 minute time peri -
od .
The bar with the white border on the outer right
shows the current average consumption or the
current recuperation quantity . After 5 minutes,
this bar travels a step to the left and a new bar
appears in the outer right.
The filled bars show the values for the current
drive cycle. Once the ignition is switched off and
on again, all of the previous bars are displayed as
104
not filled and new filled bars appear on the right.
This is so that the values from the previous trips
and the current trip can be compared visually .
Vehicle tool kit and tire repair set
Applies to vehicles: with hybrid drive
Fig. 115 Luggage compartmen t : vehicle tool bag and tir e
repair set
The vehicle tool kit is found under a cover in the
cargo floor ~
fig. 115 @ .
The tire repair set (Tire
Mobility System) is found in the storage com-
partment in the right side trim panel @ .
Additional information about the vehicle tool kit
may be found under ~ page 254 and about the
tire repair set under ~ page 257 .
@
Tips
The right storage compartment
in the lug-
gage compartment
and its contents must al-
ways be kept in the vehicle. The vehicle must
not be operated without the tire repair set .
Charging the batteries
Applies to vehicles: with hybrid drive
The vehicle is equipped with two 12 volt batteries
and a high voltage battery.
If
the 12 volt batteries are dead , they may be
charged with a charger or the vehicle may be
jump started with assistance from another vehi-
cle in the same way as a conventional vehicle.
The same applies to the high voltage battery if it
is discharged. However, in this case, the charging
process is accompanied with messages in the in-
strument cluster display. The ignition must be
switched on and all unnecessary electric compo-
nents must be turned off.
..,.
Advertisement
Table of Contents
