Table of Contents
Advertisement
Opening
and closing
Rolling code programming
Applies to: vehicles with garage door opener (Homelink)
On some systems, programming a rolling code is
also necessary.
Identifying a rolling code
"' Press the button in the control unit that is al-
ready programmed again and hold it down.
"'Watch the green LED
(D
¢
page 36, fig. 32. If
the green LED blinks quickly, the system (such
as a garage door) has a rolling code.
"' Program the rolling code as follows:
Activating the system motor unit
"' Locate the programming button on the system
motor unit. The exact locat ion and color of the
button may vary depending on the system man-
ufacture r's brand .
"'Press the programming button on the system
motor unit (usually this will activate a "display"
on the motor unit). You now have approximate-
ly 30 seconds to program the button in the
contro l pane l.
Programming the button in the control
panel
"' Press the previously programmed button in the
contro l pane l for 2 seconds.
"'To complete rolling code programming, press
the button again for 2 seconds.
"' On some systems, the button might need to be
pressed a third time to end the programming
procedure.
After programming, the system should recognize
the signal and operate when the button in the
control panel is pressed . Now you may program
the other buttons as needed.
(D
Tips
- The rolling code can be programmed more
quickly and more easily with the help of a
second person.
- If any difficulties occur when programming
the rolling code, it may be helpful to read
the system operating manual.
38
Advertisement
Table of Contents
