Table of Contents
Advertisement
Instruments
and indicator
lights
Drive
with reduced engine performance
(avoid
high speeds for extended periods of time and/ or
fast acceleration) and have the malfunction cor-
rected. See an authorized Audi dealer or author-
ized Audi Service Facility.
The indicator may turn on if the electronic speed
lim iter is fau lty . For additional information,
refer
to
c>
page 75, Electronic speed limiter.
On-Board Diagnostics
Fig. 4 Locat ion of Data Link Connector (DLC)
On-Board Diagnostics monitors the components
of your emission control system. Each monitored
18
component
in your engine system has been as-
signed a code . In case of a malfunction, the com-
ponent will be ident ified and the fault stored as a
code in the control module memory.
The MIL light may also illuminate if there is a
leak in the on-board fuel vapor recovery system.
In order to make an accurate diagnosis, the st or-
ed data can only be displayed using spec ial d iag-
nostic equipment (generic scan tool for OBD).
In orde r to connect the special d iagnost ic equip-
ment, push the plug into the Data Link Connector
(DLC). The DLC is located to the right of the hood
release
c>
fig. 4.
Your authorized Audi dea ler or a qua lified service
station can interpret the code and perform the
necessary repair .
&
WARNING
Do not use the diagnostic connector for per-
sonal use. Incorrect usage can cause malfunc -
tions, which can increase the risk of a co lli-
sion!
-
Advertisement
Table of Contents
