Table of Contents
Advertisement
....
N
a:
CX)
....
I.Cl
U"I
N
I.Cl
....
Programming the transmitter
Applies to: vehicles with garage door opener (Homelink)
Fig. 33
Distan ce betwee n the radia tor grille and the re-
mote control transmitter
Programming the button: step 1 on the
control panel
1.
Switch on the ignition .
2 . Press both of the outs ide buttons on the con-
trol unit ¢
page 36, fig. 32
until the yellow
LED@ turns off and the green LED
CD
blinks.
This procedure clears the standard codes that
were set at the factory and does not need to
be repeated again to program the other but-
tons .
3 . Briefly press the button in the cont rol panel
that you want to program .
4.
Wait until the yellow LED@ blinks. The pro-
gramming mode is active for 5 minutes.
S. Go in front of the vehicle with the original re-
mote control transmitter for the system that
you are programming to the control panel
button.
Programming the button: step 2 at the
radiator grille
6 . Hold the remote control transmitter at the
vehicle radiator grille
¢ fig. 33 .
7 . Now press the remote control transmitter
until the turn signals on your vehicle blink.
This can take up to 30 seconds.
8 . If the emergency flashers blink three times,
the programming was successful. If the
emergency flashers only blink one time, the
5 minute time limit for programming has ex-
pired or the programming was unsuccessful.
Repeat the programming starting from the
third step or change the distance to the radi-
ator grille.
Open in g and closing
9. If the garage door or other systems do not
open with the Home link buttons even if the
programming was successful, the system
may use a rolling code instead of a fixed
code. You must also then perform rolling
code programming
¢
page 38 .
The other two buttons in the control panel can be
programmed using the instructions given above.
Start with step 3.
Deleting button programming
The programmed buttons cannot be deleted indi-
vidually, they must be deleted all at once. Repro-
gram the buttons if necessary.
"' Switch on the ignition.
"' Press both of the outside buttons on the con-
trol unit until the yellow LED@ turns off and
the green LED
CD
blinks .
Reprogramming buttons
"' Switch on the ign ition.
"' To reprogram an individual button, press the
desired button until the green LED
CD
turns off
and the yellow LED@ starts to blink (after ap-
proximately 20 seconds). Release the button
immediately. The programming mode is active
for 5 minutes .
"' Continue with step 5 .
@
Tips
- The d istance needed between the remote
control transmitter
and the Homelink mod-
ule in the radiator grille
¢
fig. 33
depends
on the system you are programming.
- Depending on the system model, you may
need to release the button on the remote
cont rol transmitter wh ile it is programming
and press it again. Hold every position you
try when programming for at least 15 sec-
onds before try ing a new position. Keep an
eye on the vehicle turn signals whi le doing
this.
37
Advertisement
Table of Contents
