Table of Contents
Advertisement
Emergency
assistance
The tire repair is only meant for temporary use .
Change the spare t ire as soon as possible ¢ .&.
If the tire is pierced by an object such as a nail,
do not remove the object from the tire .
The tire repair set is able to be used at tempera-
tures as low as - 4 °F (- 20 °C).
The tire mobility kit may not be used:
- If the t ire has cuts or punctures that are larger
than 0 .1 6 in (4 mm) @ ¢ fig. 200.
- if the rim is damaged @ .
- if you drove with very low tire pressure or with-
out air in the tire @ .
See an authorized Audi dealer or authorized Audi
Service Facility for assistance in these situations.
,&
WARNING
- Please note that the tire mob ility kit cannot
be used in all situations, and that it may on-
ly be used temporari ly.
- The tire sealant must not come in contact
with skin, eyes, or clothes.
- If tire sealant gets in your eyes or on your
skin, thoroughly rinse the affected area im-
mediately with clean water.
- Do not inhale the fumes .
- If you swallow any of the t ire sealant, thor-
oughly rins e your mouth immediately and
dr ink a lot of water. Do not induce vomiting.
Seek medical attention immediately.
- Change your clothes immed iate ly if they get
tire sealant on them.
- If an allerg ic reaction occurs, see k immedi-
ate medical attention.
- Keep the tire sealant away from children .
(D
Tips
- If sealan t lea ks, allow it to dry in place. You
can then pee l it off like a sticker.
- Note the expiration date on the sealant bot-
tle . Replace the tire sealant at an author-
ized Audi dealer or authorized Audi Service
Facility.
- Radio reception can be interrupted when
operating the compressor *.
- Obey all laws.
278
Repairing tires
Applies to: vehicles with t ire mo bility kit
Fig. 201 Components of th e t ire mobility kit
Fig. 202 Tire mobility kit connection
Requirement: the tire mobility kit must be laid
out and ready for use ¢ page 2 77 .
Installing the tire mobility kit
.,. Open the cover @ on the compressor
¢fig .
201.
.,. Remove the connector © and pressure hose ®
with pressure gauge from the housing.
.,. Install the compressor pressure hose ® onto
the flange @ of tire sealant bottle @ .
.,. Insert the sea lant bottle with the flange at the
bottom into the open ing @ on the compressor
cover .
.,. Remove the valve cap from the faulty tire .
.,. Insta ll t he filler hose @ onto the valve
(j)
¢ fig.
202.
.,. Connect the p lug ©
c>
fig.
201 to a socket in
the vehicle .
.,. Switch on the ignition .
Inflating a tire
.,. Move the switch @ ¢ fig. 202 on the compres-
sor into position I.
..,.
Advertisement
Table of Contents
