Graco GM 3000 Instructions-Parts List Manual page 6

Setup
i '
. . . -
A
CAUTION
To avoid damaging the pressure control, which may
damage, follow these precautions.
result in poor equipment performance and component
1.
Always use nylon spray hose. Never use a wire
braid hose; it is too rigid to act as a pulsation
dampener.
2. Always use a minimum hose length of
50
foot
(15
m)
x
1/4
inch ID or 50 foot (15 m)
x
3/8 inch
ID hose.
3. Never install any shutoff device between the filter
(21) and the main hose. See Fig. 2.
4.
Always use the main filter outlet (20) for a one
gun operation. Never plug this outlet.
1.
Connect hose and gun. (Refer to Fig. 2.)
a. Remove the plastic cap from the
1/4
npsm (m)
filter outlet nipple
(20).
Screw the main fluid
hose onto the nipple. Read the CAUTION,
above.
b. Connect the whip end hose between the main
fluid hose and the inlet adapter of the gun.
. the spray tip yet!
c. Do not use thread sealant, and do not install
If you supply your own hoses and spray gun, be
sure the hoses are electrically conductive, that the
gun has a tip guard, and that each part is rated for
at least 3000
psi
(210
bar) Maximum Working
caused by static sparking, fluid injection or over-
Pressure,
This is to reduce the risk of serious injury
pressurization and rupture of the hose or gun.
2. Fill packing nuffwetcup. Fill the packing nut/wet-
cup (A) 1/3 full with Graco Throat Seal Liquid
(TSL), supplied. See Fig. 2.
l ,
. .
. .
3.
Check the engine
oil level.
Refer
to
the Honda
engine manual, supplied. This is a summary of the
the oil should be almost overflowing. See Fig. 3.
information: Remove one of the oil fill plugs (M);
Add oil as necessary.
Recommended lubrication oil: Use a high-quality,
detergent oil, SAE
IOW-30,
classified "FOR
SERVICE SG or
SF".
for regular use and for
breaking-in a new engine.
21 Fluid Filter
46
Pressure drain valve
20 114 npsm(m) fluid outlet
A
Wetcup
05832
6
308-620