Graco GM 3000 Instructions-Parts List Manual page 27

. .
Engine
i
NOTE: The engine must be removed before the
Clamp and Clutch Housing can be removed.
A
CAUTION
The sprayer will be out of balance when the engine,
clutch housing, drive housing and pinion housing are
partially disassembled sprayer from falling over.
removed. Support the rear of the cart to prevent the
A
CAUTION
The sprayer will experience poor clutch life if a
replacement engine is purchased from another
vendor. The engine for this sprayer is manufactured
by Honda to a special Graco specification.
1. Working under the mounting plate (A), remove the
two lock nuts
(78) and then pull the screws (77)
out of the base of the engine. Remove the screw
( 6 1 ) . lock washer (62) and washer (60). Discon-
nect the red wire
(E)
from the engine lead (D).
Disconnect the black and white wires from the
field. Pull the cable (E) carefully through the grom-
50
met (50) before removing the engine. See Fig. 16
and 17.
(,
2 . Lift the engine carefully and place it
on
a work
bench.
3. Remove the Field and Wiring Harness, Clamp
and Clutch Housing, as instructed on page 2 8 .
""d
' I /
@
NOTE:
All service to the engine must be performed by
6 2 a
A
78
an authorized Honda dealer.
A 6 1
I$
A
D
Fig.
17
A
Apply low strength thread locker
m 8 m
' I
Bottom View of Engine and Cart
Fig.
16
308-620' 27