Table of Contents
Advertisement
A ss is t
km/h), which is the minimum speed that can
be set.
(D
Tips
- If you switc h the ignition or the adapt ive
cruise control system off, the set speed is
erased for safety reasons.
- The electronic stabilization control (ESC)
and the anti-slip -regulation (ASR) are auto-
matically sw itched on when the adaptive
cruise control is switched on.
Changing the speed
Applies to: vehicles with Audi adapt ive cruise control
0
,
•
0
Fig. 96
Operat ing lever: changing the speed
~
co
N
0
±
~
.. To increase or red uce the speed in increments,
tap the lever up or down.
.. To increase or decrease the speed quickly, hold
the lever up or down until the red LED@ reach-
es the desired speed
¢
page 91, fig. 95 .
After each change, the new stored speed appears
briefly in the information line ¢
page 91, fig. 95
@.
Driving in stop-and -go traffic
Applies to: veh icles with Audi adapt ive cruise control
The adaptive cruise contro l system also assists
you in stop-and-go t raff ic.
Stopp ing automatically
If an object ahead stops, your veh icle will brake
and stay at a stop, with in the limits of the sys-
tem. The Start/Stop system* can be used as usu-
al.
92
Driving manually
.. Tap the accelerator pedal, or
.. pull the lever toward you into pos ition @ .
@
Tips
If an obst acle is detected when you r vehicle
starts moving, the dr iver intervent ion reques t
appears¢
page
94 . Your vehicle will drive
more slowly when starting. This may a lso
happen in some situations when there is no
apparent obstacle.
Interrupting cruise control
Applies to : vehicles with Audi adaptive cruise control
Fig . 9 7
Selector lever
Requirement: adaptive cruise control must be
switched on .
Overriding cruise control
.. To accelerate ma nua lly, pull the lever toward
you into posit ion @ and hold it there . The mes-
sage ACC: override appears. Or
.. press the accelerator peda l.
.. To resume cruise control, release the lever or
take your foot off the accelerator pedal.
Canceling cruise control whil e driving
.. Move the lever into position @ . The message
ACC: standb y appears . Or
.. press the brake pedal.
.. To resume the stored speed, move the lever in-
to position @ .
Canceling cruise control when stopped
.. Push the lever away from you into position @ .
The message ACC : standby appears.
..,.
Advertisement
Table of Contents
