Table of Contents
Advertisement
co
co
....
N
"
N
....
0
00
\.J
'<t
- Always make sure the forward-facing seat
has been designed and certified by its man-
ufacturer for use on a front seat with a
passenger front and side airbag.
- Never put the forward-facing child restraint
up, against or very near the instrument pan-
el.
- Always move the front passenger seat to
the highest position in the up and down ad-
justment range and move it back to the
rearmost position in the seat's fore and aft
adjustment range, as fa r away from the air-
bag as possib le, before insta lling the for-
wa rd-facing child restra int.
- Always make sure that the safety belt upper
anchorage is beh ind the child restraint and
not next to or in front of the chi ld restraint
so that the safety belt will be properly posi-
tioned.
- Make sure that the PASSENGER AIR BAG
OFF light comes on and stays on all the time
whenever the ignition is switched on .
_&.
WARNING
Rearward-facing child restra ints:
- A ch ild in a rearward-facing child safety seat
installed on the front passenger seat will be
seriously injured and can be killed if the
front airbag inflates - even with an Ad-
vanced Airbag System.
- The inflating a irbag will hit the child safety
seat or infant carrier with great force and
will smash the ch ild safety seat and child
against the backrest, center armrest, door
or roof .
- Always be especially careful if you must in-
stall a rearward facing child safety seat on
the front passenger seat in exceptional cir-
cumstances.
- Make sure that the PASSENGER AIR BAG
OFF light comes on and stays on all the time
whenever the ignition is switched on.
- If the PASSENGER AIR BAG OFF light does
not come on and stay on, immediately in-
sta ll the rear-fac ing ch ild safety seat in a
rear seating position and have the airbag
system inspected by your Audi dealer .
Ch ild safety
Activating the convertible locking retractor
Use the convertible locking retractor to secure a
child restraint .
Always heed the ch ild safety seat manufacturer 's
instruct ions when installing a child restraint in
your vehicle. To activate the convertible locking
retractor:
.. Place the child restraint on a seat, preferably
on the rear seat .
.. Slowly pull the belt all the way out .
.. Route it around or through the child restra int
be lt path ¢ &_ .
.. Push the ch ild safety seat down with you r full
weight to get the safety belt really tight.
.. Insert the belt tongue into the buckle for that
seating position.
.. Guide the safety belt back into the retractor un-
til the belt lies flat and snug on the child safety
seat .
.. You should hear a ''cl icking" noise as the belt
winds back into the inertia reel. Test the con -
vert ible locking retractor by pull ing on the belt .
You shou ld no longer be able to pull the belt
out of the retractor. The convertib le loc king re-
t ractor is now activated.
.. Make sure that the red release button is facing
away from the child restraint so that it can be
unbuckled quickly .
.. Pull on the belt to make sure the safety belt is
properly tight and fastened so that the seat
cannot move forward or sideways more than
one inch (2 .5 cm) .
,&.
WARNING
Using the wrong ch ild rest raint o r an improp-
e rly installed child restra int can cause se rious
personal injury or death in a crash.
- Always make sure that the safety be lt re-
tr actor is locked when installing a child
safety seat . An un locked safety be lt retrac-
tor cannot hold the chi ld safety seat in place
during normal driving or in a crash.
- Always buckle the child safety seat firm ly in
p lace even if a child is not sitting in it. A
loose child safety seat can fly around during
a sudden stop or in a crash.
.,.
185
Advertisement
Table of Contents
