Advertisement
@ Editing Interruption
eDo not press the following buttons while the Edit Start
Button is flickering, that is, after setting the Edit Start
points or pressing the Edit Start Button.
STOP-FF-REW-EJECT Button
®Also, do not press the Edit Stop Button when the end point
has not yet been reached. If you do press it, editing will be
interrupted, and the editing operation will stop without the
edit start and end points being erased.
Be sure that the editing operation has been completed
before proceeding to the next operation.
*Edit Automatic Stop Selector (Rear Panel)
OFF [
@JON
If the servo operation becomes disturbed
after the edit start point, the VTR will
automatically stop.
OFF[M™l_ JON
The VTR will continue operating even if
the servo becomes
disturbed after the
edit start point.
When editing is performed with the unit
connected to Editing Controller AG-A750
however, a warning buzzer will sound in
the event of a servo disturbance caused
by the controller.
unit only):
© During editing, when the edit OUT point is not entered and
the EDIT STOP button is pressed, the position at which the
editing is stopped will be entered as the OUT point. The
tape will then overrun 8 frames and be edited. Afterwards,
the tape will return to the OUT point.
¢ During normal playback, when editing is started with the
EDIT START
button, the position at which the button is
depressed will be entered as the edit IN point and the unit
will start editing 8 more frames after the IN point.
Advertisement
