Advertisement
Hf Insert editing
Recording Switch.
Direction of tape movement
eee
"RS (6808 09 CLS A Oe SA OE A WO HE SUE 2
OG LAS MR
YIM.
Normal Audio CH2 track
Normal Audio CH1 track
Video/HD Sound track
Control track
Normal Audio CH2 track
Normal Audio CH1 track
LE
:
Control track
End point for insert editing
Video/HD Sound track
point for insert editing
tS
SG
2
A OO
DD 3
Normal Audio CH2 track
Selecting Editing Mode
goes
onary eee
however.
Esiting
Button |! video/HD | Audio CH1 | Audio ora
Signal
-_—
——=
——
Video/HD Sound
ON
OFF
Video/HD Sound
Video/HD Sound
Normal Audio CH1
OFF
ON
Normal Audio CH2
OFF
OFF
Normal Audio
FF
ON
CH1/CH2
2
il
For details of pre-operating checks, refer to the items on
page 16~23.
Operating Procedure
1. Press the Power Switch to the "ON" side.
2. Load the cassette tape.
3. Check the programme to be edited using a TV monitor.
Press the Play Button. The signals already recorded on the
tape will be played back. By pressing the Record Button
while playback is taking place, you can observe the E-E
signals which you are trying to record. The E-E signal will
be maintained as long as the button is kept pressed. These
signals will not be recorded on the tape, however.
4. Verify that the Play Lamp or both the Play Lamp and the
Pause/Still Lamp are lit.
Select the Video/HD, Audio CH1, and Audio CH2 buttons,
corresponding to the signals to be inserted.
(Refer to "Selecting Editing Mode" on this page.)
©The button is a self-illuminating type. When it is pressed, it
will light; by pressing it again, it will go out.
wause srw
(Refer to "Selecting Editing Mode" on this page.)
If you attempt to start editing by pressing the Edit Start
Button without selecting the editing mode, the four
Editing
Mode
Select
Buttons
will flash six times,
reminding you to select the desired editing mode.
After selecting the mode, press the Edit Start Button.
After selecting the editing mode, the In and Out Buttons
will flash.
EOIT POINT
flash
5. Press the Search Button, then using the Search Dial
search for the edit start point, and put the unit in the still
mode. (See page 14~15.)
<Caution>
Press the Reset Button on the Tape Counter to reset the
counter to "0:00:00:00". When
the counter is reset, the
previously set edit start and end points will be erased.
MEMORY
RESET
ON
OFF
Advertisement
