Advertisement
Audio Monitoring
You can monitor audio using one of the following four
methods.
@ When using headphones
When
using headphones, you can
adjust the volume using this control.
To reduce the audio level, move the
control to the left, and vice versa.
Headphone
Jack
Headphone
Level
Control
Use headphones.
(1/4" phone jack)
elf you use high impedance
headphones, the audio level
may change.
®HD or Normal Sound can be selected as indicates below.
® Select the monitoring audio using the
method @ or @.
@ Audio Monitor Selector
METER
You Can listen to the audio source
CHI
HD
selected by two switches (@, @),
Mix
using the Headphone Jack or Audio
cH2
NORM
Monitor OUtput Jack.
AUDIO MONITOR
@ This
switch
is used
to select
the type of audio
(HD/Normal) to be monitored. The movement of the
pointer of each meter will also change when this switch
Headphone Jack
is operated.
Audio Monitor
:
:
Audio CH1/CH2
Audio Monitor
Oulput ee
HD
HD Sound level
NORM
indication
HO
Normal Audio
Normal Audio
NORM
level indication
@ This switch is used for selecting the audio output
signal source.
Audio Monitor
Audio Monitor
Selector
Output Jack
Headphone
Jack
will be audible
Right side:
The
audio
of CH2
will be audible
@ When monitoring audio using the Audio
Output (NORM/HD) Jacks (CH1/CH2)
When monitoring audio using the Audio Output Jacks on
the back of the unit, you can output the following audio
signals using the Audio Output Selector.
Audio Output
Audio Output
Selector
Jacks
e
When HD Sound is not recorded on the tape, only
Normal Audio will be output from the output terminals,
even if the selector is set to the "HD" side. Also, at this
time, the HD lamp will be out.
@ When HD Sound is recorded on the tape, the HD lamp
will light even if the selector is set to the "NORM" side.
@ When a tape recorded with HD Sound is played back
and the tracking control is not set for optimum tracking,
normal audio will be output even if the selector is set to
the "HD" side. In this case, the HD lamp will be out.
Normal
Audio
© When using HD Sound Output Jacks
When playing back an HD Sound recorded tape, HD
Sound will be obtained from these jacks.
But when only normal sound is recorded on the tape, no
HD Sound will be obtained from these jacks.
Video Level Adjustment
@ Set the Input Signal Selector according to
the equipment connected to the unit.
To ensure a coloured picture with minimal jitter when
dubbing, set the switch to the position which matches
the particular application.
connected to the 4P S-VIDEO Input Connector,
se
To record video signals from a video source
set the Input Selector to the "S-VIDEO" position.
connected to the Video Input Connector, set the
To record video signals from a video source
LINE
Input Selector to the "LINE" position.
connected to the Dubbing Input Connector, set
a
record video signals from a video source
DUB |@) the Input Selector to the "DUB" position.
Advertisement
