Advertisement
ier
ee
Ee
6. Press the In and Set Buttons simultaneously to set the edit
start point. When these buttons are pressed, the In Button
will light to indicate that the edit start point has been set.
@At this time, the Edit Start Button will flash.
©The edit in point can be confirmed at any time after it has
been entered by simply pressing the In Button.
See "Checking Edit Set Points" on the next page.
7. Using the Search Dial once again, search for the edit end
point, and when the unit is in a pause status, press the Out
and Set Buttons simultaneously to set the edit end point.
The Out Button will immediately light to indicate that the
edit end point has been set.
VIDEO eae
CH1- AUDIO - CH?
our
o
-O-
i
-
«
>
~
©The edit out point can be confirmed at any time after it has
been entered by simply pressing the Out Button.
See "Checking Edit Set Points" on the next page.
EDIT POINT
e€ort START
€o1t STOP
Id]
flash *
8. Press the Edit Start Button to start editing.
Se
ae
opoo
E0IT START
EDIT STOP
<Caution>
®This unit can record the S-VHS tape in both S-VHS and
VHS
modes.
Therefore,
make
sure that the S-VHS
Selector on the editor is set to the same mode as the
recorded
tape when
editing. If the insert editing is
performed in combination of the S-VHS and VHS modes
on the single tape, the mode changing will occur at the edit
point, and the fine editing cannot be performed.
Rewind the tape by at least 3 seconds from the edit start
point until the picture to be played back appears.
During insert editing, recording takes place by means of
the control signals on the pre-recorded tape. Be sure,
therefore, to perform editing on the pre-recorded portion
of the tape.
eUnless tracking
is optimum, the rotating head
may
sometimes
prevent
clean
reproduction
from
being
obtained at the edit start and end point. To prevent this,
optimize the tracking before editing. (See page 20.)
®You cannot perform insert editing of a video signal or HD
Sound signal alone. If, for example, you insert only a video
signal, the HD previous Sound at that point will be erased.
Editing Procedure
;
after about
edit start point
editend point
2sec.
<<
editing ———+<- play >!
@
point: Press the Edit Start Button to Start Editing —
eThe Edit Start Button flashes rapidly.
EDIT START
7
Ny
While this lamp is flashing, the VTR pre-rolls
e
e
back from the edit start point for 3 seconds, and
'(al _ after performing playback for about 3 seconds
s
'4 will reach the edit start point.
rapid flash
© point: Edit Start Point
©The Edit Start Button will light.
EDIT START
v
The lamp lights at the edit start point. At this time,
yy
-[C]- the video and audio signals to be edited and
pe
recorded
will appear on the TV monitor.
light
—
@ point: Edit End Point
eThe Edit Start Button flashes rapidly once again.
gw eirstant | The video and audio which were being edited will
.
e
disappear, and the pre-recorded video and audio
ml
» will appear and be played back for about 2
s
4
seconds. Then the tape will return to the adjacent
rapid flash
edit end point.
© point: Edit Exd —
AA
eThe Edit Start Button will go out, and both the In and Out
Buttons will flash slowly.
EDIT POINT
EDIT START
IN
SET
out
Ico
Goa
¥
4
x
4
go out
Lot
flash
The edit start and end point registrations will be
erased, and the tape will remain still at the edit
end point.
Advertisement
