Setting Vcare Settings In Service Mode - Konica Minolta bizhub PRO 1200 Setup Instructions

F. Setting vCare Settings in Service Mode
1. Enter Service (Tech Rep) Mode > Select [CS Remote Care].
Note: If the dipswitches had not been set correctly, the [CS Remote Care] section would be grayed
out. If this is the case, it is be necessary to restart at Section D. Step 5.
2. After selecting the [CS Remote Care] button, press the second [CS Remote Care] selection.
Konica Minolta bizhub PRO 1200/1200P 1051
bizhub vCare HTTP Setup Guide
Page 12 of 22