Introduction; Local Keypad Of The Dpxk-19B/23B/P - Barco DP K-19B Series User And Installation Manual

Input & communication

6.1 Introduction

General
The Input & Communication side of the projector consists of a Local Keypad and a card cage with four slots.
The rear side of the projector is equipped with a tail light which reflects the status of the projector.
Depending on the projector configuration the projector card cage is equipped with an ICP (-D) or ICMP (-X).
See illustration below. In case an ICP (-D) is installed then an IMB, IMS, or HDSDI input module can be
optionally inserted into the slot below the ICP(-D). Note that all information about the ICMP(-X) is gathered into
one separated chapter called ICMP.
Image 6–1
1 Fan Control Board (FCB).
2 Integrated Cinema Processor (ICP) or Integrated Cinema
Processor - Direct (ICP–D).
3 Optional slot for either IMB, IMS or HD-SDI input module.
CAUTION: A unit may only be removed from the card cage by qualified service personnel.
Removing one of the boards (except for the Cinema Controller) will result in an authorization
request upon starting.

6.2 Local keypad of the DPxK-19B/23B/P

Identification of the keys
1
Image 6–2 Local keypad
1 Marker area for macro name
2 Numeric keyboard
3 Standby key
4 Dowser open/close switch
78 R5905753 /17 DPxK-19B/23B/P
1
2
3
4
2 3 4 5
1
2
3
6
4
5
7
6
8
4 Cinema Controller.
5 ICMP(-X) (inserted in ICP slot and optional slot).
1
5
4