The Battery Pack; Nicd Battery Pack (Pb-13); Rechalging; Installing The Battery Pack - Kenwood TH-28A Instruction Manual

THE BATTERY PACK
1 NiCd Battery Pack (PB-13)
You must charge the battery before you can use it. NOTE
It has not been charged at the factory in order to Recharging should be done within an ambient
provide you with the greatest number of charge/ temperature between 5°C ~ 40°C (41°F ~
discharge cycles. It takes several charge/discharge
cycles before the battery pack will operate for its
maximum period. If you store the battery pack for
more than two months, recharge it before use.
104°F). Recharging performed out of this range
may not fully charge the battery.
2 Recharging 3 Installing The Battery Pack
Insert the charge plug from the charger (BC-14) into Insert the battery pack into the transceiver until it
the receptacle on the top of the transceiver. Then locks in place.
plug the charger into the AC line. Do not allow the To remove the battery pack slide the Release button
battery to charge for greater than 15 hours. The to the right and pull the pack down.
useful life and battery performance will be reduced if
you exceed the recommended charge period.
RELEASE button
Transceiver
BC-14
(Illustrations show the U.S.A. version.)