Vfo/Memory Scan; Call/Vfo Scan; Call/Memory Scan; V/M/C(Vfo/Memory/Call) Scan - Kenwood TH-28A Instruction Manual

3 Press and hold the VFO key for longer than one
second.
The MHz indicator will flash when the transceiver is
scanning.
Note
If the frequency in programmable band scan
memory 1 overlaps the frequency in programmable
band scan memory 2, the band stored in
programmable band scan memory 1 is also
scanned.
4 Press the PTT switch, CALL, MR or VFO key to
stop scan.
7 MHz Scan
1 Adjust the SQL control to the threshold point.
2 Start the band scan or programmable band scan.
3 Press the MHz key during band scan or
programmable band scan. Scanning begins in an
upward sequence over a 1 MHz.
Example: If the MHz key is pressed when the
frequency is 145.02 MHz for VHF band scan, just the
145 MHz band is scanned.
26
8 VFO/Memory Scan
1 Press the F key, then press the MR key.
2 The VFO frequency and the last used memory
channel are scanned alternately.
3 Press the PTT switch, CALL, MR or VFO key to
stop scan.
9 CALL/VFO Scan
1 Press and hold the CALL key for longer than one
second in VFO mode.
2 The display frequency and CALL frequency are
scanned alternately.
10 CALL / Memory Scan
1 Press and hold the CALL key for longer than one
second in memory channel mode.
2 The memory channel in use and CALL frequency are
scanned alternately.
11 V/M/C(VFO/Memory/CALL) Scan
1 Press the F key, then press the CALL key.
2 The VFO frequency, last used memory channel, and
CALL frequency are scanned alternately.