Memory Expansion Unit (Me-1) - Kenwood TH-28A Instruction Manual

2 Memory Expansion Unit (ME-1)
1
oOo nN
a #
Slide the release button to unlock, then pull out the
battery case.
Unscrew the four screws on the rear (Fig. 1).
Put your finger into the battery holder, and release
the claw of the rear case. (Fig. 2)
Position the set with its front facing forward.
Open the front panel from the PTT switch side, being
careful of the internal wiring. The PC board mounted
on the front panel projects into the top panel by
about 3 mm. Pull the front panel down to open it
(Fig. 3).
6 Attach the ME-1 to the transceiver, as shown in fig.4.
7 Replace the case in its original position, taking care
=
56
not to pinch any wires or cables under the case.
Install the four screws.
Selecting the Three Digit memory Mode
Press and hold the F key for longer than one
second, then press the MR key.
2 digit mode (initial state)—3 digit mode >
1 digit mode—2 digit mode
Repeat as required until the desired mode has been
selected.
Fig. 1
Fig. 3
Fig. 2
Fig. 4