Level Rangc; Install Griddle; Electronic Ignition Systern - Jenn-Air JDRP548WP02 Installation Instructions Manual

iy PLP LER PO pens si, pag
nic ignition Sysiem
Doge, p e n , FG peonacuping sping gate oe
Level Range electronic ig
NOTE: Range must be level for satisfactory baking performance.
4. Place rack in oven. Install Burner Bases and Burner Caps
2. Place level on rack and check levelness of the range, first
side to side: then front to back. Install the burner base, making sure the igniter electrode is
properly aligned with the base. Place burner caps on top of
burner bases. If burner caps are not properly positioned, surface
burners will not light.
20,000 Btu/h Ultra Power™ Dual-Flame
Burner
A. Incorrect
3. If range is not level, adjust the leveling rods. Turn leveling B. Correct
rods located behind the kick plate to level range and to raise
or lower range to the desired countertop height.
NOTE: All roller feet must be off the floor upon final installation.
A. Incorrect
B. Correct
"A
B
A. Incorrect
B. Rear leveling rod
(on griddle
The griddle is factory install
1. Place drip tray in the well at the front of the griddle. Slide tray
toward the back until it stops. Initial Lighting and Gas Flame Adjustments
Cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues until the flame is lit or the Knob is turned to Off.
Check Operation of Cooktop Burners
Push in and turn each control knob to the "LITE" position.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit, it may take longer than
4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control knobs
A. Griddle drip tray to OFF.
B. Griddle If burners do not light properly:
m= Turn cooktop control knob to the "OFF" position.
2. Clean griddle before using. Refer to the Use and Care Guide.
m Check that the range is plugged in and the circuit breaker has
not tripped or the fuse has not blown.
m Check that the gas shutoff valves are set to the "open"
position.
m Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
14