Table of Contents
Advertisement
Available languages
Available languages
Level Range
NOTE: Range must be level for satisfactory baking performance.
1.
Place rack in oven.
2.
Place level on rack and check levelness of the range, first
side to side; then front to back.
3.
If range is not level, adjust the leveling rods. Turn leveling
rods located behind the kickplate to level range and to raise
or lower range to the desired countertop height.
NOTE: All roller feet must be off the floor upon final installation.
A. Front leveling rod
B. Rear leveling rod
(on griddle mo
The griddle is factory installed.
1.
Place drip tray in the well at the front of the griddle. Slide tray
toward the back until it stops.
A. Griddle drip tray
B. Griddle
2.
Clean griddle before using. Refer to the Use and Care Guide.
Install Burner Heads and Caps
Install the burner head, making sure the alignment pins are
properly aligned with the burner base. Place burner cap (black)
on top of the burner head.
20,000 Btu/h Ultra Power™ Dual-Flame
Burner
A. Incorrect
B. Correct
A. Incorrect
B. Correct
5,000 Btu/h Simmer/Melt Burner
eee
Cee
T
A. Incorrect
B. Correct
ae
Initial Lighting and Gas Flame Adjustments
Cooktop burners use electronic igniters in place of standing
pilots. When the cooktop control knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues, until the flame is lit or the knob is turned to Off.
Check Operation of Cooktop Burners
Push in and turn each control knob to the "LITE" position.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit it may take longer than
4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control knobs
to OFF.
If burners do not light properly:
m=
Turn cooktop control knob to the "OFF" position.
m
Check that the range is plugged in and the circuit breaker has
not tripped or the fuse has not blown.
m
Check that the gas shutoff valves are set to the "open"
position.
m
Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
15
Advertisement
Table of Contents
