Table of Contents
Advertisement
48
1-2. Using Advanced Drive
When control phase has been entered
■
Even if the control phase is canceled, the
advanced driving support temporarily can-
not be used.
To enable use, turn the power switch off and
then back to ON mode.
Stop phase
After the vehicle is stopped, a buzzer
will sound in short intervals and the
parking brake will be engaged auto-
matically.
■
Stop phase operation
●
The emergency flashers flash continu-
ously to warn other drivers of the emer-
gency.
●
The emergency flashers can be turned off
by pressing the emergency flasher switch
2 times.
●
When the buzzer is sounding, the audio
system will be muted.
Cancelling the stop phase
■
If any of the following are performed, the
stop phase will be canceled:
The LTA (Lane Tracing Assist) switch is
●
pressed with the P shift position selected
●
The Advanced Drive main switch is
pressed with the P shift position selected
●
After the P shift position is selected, the
shift position is changed to any position
other than P
The power switch is turned off
●
■
When stop phase has been entered
Even if the stop phase is canceled, the
advanced driving support temporarily can-
not be used.
To enable use, turn the power switch off and
then back to ON mode.
Also, it may be necessary to hold the steer-
ing wheel for a certain amount of time while
the advanced driving support is operating.
Advertisement
Table of Contents
