Watchguard Firebox V10 Installation Manual page 86

Watchguard firebox v10 firewall: install guide

Hide thumbs Also See for Firebox V10:

Table of Contents

CHAPTER 4: Completing the Vcontroller Installation Wizard

When the appliance has been fully turned on, you should see the

following lights on the front of the device:

- If you have connected the appliance to a network or to a

computer, one of the Ethernet10/100 indicator lights should be

lit (or, in the Firebox V100, the Link light will be lit).

- The Ready LED should blink while initialization is underway,

then be steadily lit.

Start the Vcontroller software.

After successfully logging into the appliance with Vcontroller (as

described in the System Administration Guide) you can now proceed

with other set-up and customizing tasks (also described in the System

Administration Guide).

Vcontroller 3.2

Table of Contents

Firebox v100 Firebox v200 Firebox v60 Firebox v60l Firebox v80