Watchguard Firebox V10 Installation Manual page 27

Do not connect any Firebox Vclass appliance to a source of power that
supplies the wrong voltage. Doing so will damage the appliance and void
the warranty.
The power supply can auto-detect 110/220 voltage.
Installation Guide
Power switch
Amperage switch
UPS interface
Key features of the Firebox V60 and V80 appliances
N
OTE
Press this switch to power up or to power down
the appliance. To power up the appliance, press
this switch after connecting the appliance to a safe
power source. To power down the appliance,
perform a software shutdown, then wait for the
status LEDs on the front to dim. Wait 30 seconds
after the LEDs go dim. At that point it is safe to
press this switch to cut power.
This switch allows you to change the power
source between 115 and 230 volts, depending
upon your supply.
N
OTE
This interface permits connection of the appliance
to an Uninterruptable Power Supply (UPS). You
should use the cable provided in the appliance
packaging for this connection. This type of
connection enables suitably configured UPS
devices to notify the appliance if the power goes
out, prompting the appliance to shut itself down
properly.
UPS devices from American Power Company (APC)
are currently supported by the Firebox Vclass
power management firmware. Check
WatchGuard's Web site (www.watchguard.com) for
updated information on complete UPS support.
11