Watchguard Firebox V10 Installation Manual page 52

CHAPTER 3: Starting the Firebox Vclass Appliance Setup
of, including Linux versions and JRE versions. For additional updates, be
sure to check the WatchGuard Web site.
To install the Vcontroller, follow these steps:
1
2
3
4
5
If this is an older version of JDK, the installer will alert you and ask if you
prefer to use it instead of a more recent version. You can do so, but we
recommend that you obtain and install the most recent version
6
7
36
Insert the WatchGuard CD into the CD-ROM.
Under Linux, you must then type the following command to mount
the CD:
mount /dev/cdrom -t iso9660 /mnt/cdrom
Run this command:
cd /mnt/cdrom
Now run this command:
./setup.sh
During the resulting software installation process, the installer will
ask you if you have already installed the latest versions of the Java
Run-time Environment and JDK. If you have done so, you must type
Y and then type the pathway to the JRE/JDK directory.
The installer will locate and assess this JDK collection.
If you haven't installed JRE/JDK, type N. The installer will quit, but
when it does, it will provide information on where on the Sun Web
site to obtain the proper version of JRE/JDK software. (N.B. The
default JDK install location is the current user's home directory,
however you can type another directory at this time.)
When the JDK software has been installed (and any needed Solaris
updates are completed), run this command:
cd /cdrom/watchguard
Then run this command:
./setup.sh
This will restart the installation process.
N
OTE
Vcontroller 3.2