Watchguard Firebox V10 Installation Manual page 61

3
4
5
6
7
8
9
10 When the WG(config-if)# prompt appears, type the interface number
11 When the WG(config-if)# prompt reappears, type exit to submit this
12 Type exit at the prompt and press Enter.
13 To verify the complete change of addresses, type show system
Installation Guide
When the Ready LED on the front of the appliance is steadily lit, you
can begin the CLI process.
On your administrative workstation, open a terminal window. The
serial connection parameters include the following:
9600bps, 8 data bits, no parity, 1 stop bit, with Xon/Xoff flow control.
Once the workstation has connected to the security appliance, the
following prompt appears in the terminal window:
watchguard firebox v80 (os 3.X)
WatchGuard login:
Type admin (the default root administrative account login name) and
press Enter.
When the password prompt appears, type admin and press Enter.
If the login connection is successful, the WG# prompt appears.
Type conf and press Enter.
When the WG(config)# prompt appears, type system and press Enter.
When the WG(config-system)# prompt appears, type interface and
press Enter.
(0, 1 or 2), followed by a space, the IP address, another space, the
subnet mask and then press Enter.
Example: WG(config-if)#0 192.168.2.1 255.255.255.0
interface address change.
After a moderate pause, a status message will appear, noting the
effective change to this interface.
A new WG(config)# prompt appears below this message.
The WG# prompt reappears.
interface at the prompt and press Enter.
A full report appears, followed by the WG# prompt.
Extra: Using the WatchGuard CLI to record an IP address
45