Configuring Split Tunneling; Using Muvpn Clients - Watchguard Firebox SOHO 6 Wireless User Manual

Chapter 9: VPN—Virtual Private Networking

Configuring Split Tunneling

The split tunneling feature allows the system administrator to
direct all Internet traffic from the trusted network through the
VPN tunnel. Without split tunneling, only traffic directed to the
other end of the VPN tunnel is sent through the tunnel and the
traffic for other Internet addresses is sent directly to the Internet.
Split tunneling allows the control of access to Internet Web sites
from one location.
To set up split tunneling follow these steps:
1 Type the IP address of the trusted network in your browser
window to connect to the System Status page of the SOHO 6
Wireless.
The default IP address is: http://192.168.111.1
2 From the navigation bar at left, select
VPN => Manual VPN.
The Manual VPN page opens.
3 Click Add.
The Add Gateway page opens.
4 Configure the gateway.
See "Setting Up Multiple SOHO 6 Wireless to SOHO 6 Wireless VPN
Tunnels" on page 111 for information about the Add Gateway page.
5 Type the network IP address of the local network and remote
networks in the applicable fields.
6 Click Submit.

Using MUVPN Clients

The MUVPN Clients upgrade allows remote users to connect to the
SOHO 6 Wireless through a secure (IPSec) VPN tunnel. This option
allows remote users to connect to the SOHO 6 Wireless through an
116 WatchGuard Firebox SOHO 6 Wireless