Vpn Management - Watchguard Firebox SOHO 6 User Manual

Chapter 12: Support Resources
SOHO 6 configuration file. These steps apply to using a command
prompt with Windows 2000 or XP.
1 Configure the firewall settings of the SOHO 6 to allow an
incoming FTP service to the trusted IP address of the
appliance.
For information on configuring an incoming service, see Chapter 6
"Configure the Firewall Settings" on page 61.
2 Select Start => Programs => Accessories = > Command Prompt.
A command prompt window appears.
3 At the prompt, type
network.
The default IP address is: 192.168.111.1
4 Press Enter.
5 You are then prompted for the username and password. Type
the system administrator name and passphrase configured on
the system security page. For information on configuring the
system security page, see "System security" on page 50.
The default values are "user" and "pass".
6 Respond to the ftp prompt as follows:
bin
ftp>
get wg.cfg
ftp>
The wg.cfg file is downloaded to the directory of the original command
prompt.
bye
ftp>
The original command prompt reappears.
exit
7 Type
The command prompt window closes.

VPN Management

See "What You Need" on page 91.
170
ftp
and then the IP address of the trusted
at the prompt and then press Enter.
WatchGuard Firebox SOHO 6