Configuring The Muvpn Client - Watchguard Firebox SOHO 6 User Manual

Using VPNforce and the MUVPN Client Upgrades to Enforce Your Corporate
5 Type an unused IP address from the trusted network, which
will be used by the MUVPN client computer when connecting
to the SOHO 6 in the Virtual IP Address field.
6 Select MD5-HMAC from the Authentication Algorithm drop
list.
7 Select DES-CBC from the Encryption Algorithm drop list.
8 Select Mobile User from the VPN Client Type drop list.
9 Select the All traffic uses tunnel (0.0.0.0/0 Subnet) checkbox.
10 Click Submit.
The page refreshes and you are prompted to reboot the SOHO 6 to activate
the changes.
11 Click Reboot.
12 Connect one end of a straight-through Ethernet cable into the
Ethernet port labeled OPT on the SOHO 6. Connect the other
end into the uplink port of the hub.
13 Connect Ethernet cables to the uplink ports of the hub and to
the Ethernet ports of each of your computers.

Configuring the MUVPN client

Before configuring the MUVPN client, you must first install it on
your computer. For information on installing the client, see
"Installing and Configuring the MUVPN Client" on page 120.
Follow these procedures to create a MUVPN security policy:
1 Right-click the MUVPN client icon and select Security Policy
Editor.
The Security Policy Editor dialog box appears.
2 Select Edit = > Add => Connection.
A New Connection appears in the Network Security Policy field on the left
side and the and the Connection Security and Remote Party Identity and
Addressing settings appear on the right side.
User Guide 153