Scan Stand Mode; Scan Stand Symbol; Presentation Mode - Wasp 2D Reference Manual

Output

Scan Stand Mode

When a unit is in Scan Stand mode, it remains idle as long as it sees the
Scan Stand symbol. (See that follows.) When a dif-

Scan Stand Symbol

ferent code is presented, the Imager is triggered to read the new code.
Note:The imager automatically adjusts the illumination LEDs to the
lowest light level possible to maintain a good lock on the Scan Stand
symbol. When a symbol is presented, the imager's light levels adjust to
the saved setting (see ).
LED Power Level on page 3-9
Scan Stand Mode
Scan Stand Symbol
When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand
symbol on the base of the stand which tells it to remain idle. When the
Scan Stand symbol is covered, the imager turns the LEDs on at the con-
figured power level (Default High) and attempts to find and decode bar
codes in its field of view.
Scan Stand Symbol

Presentation Mode

This programs the imager to work in Presentation Mode.
Presentation Mode
3-6 DuraLine™ 2D Imagers