To Add A Prefix Or Suffix - Wasp 2D Reference Manual

Data Editing
• You can add any prefix or suffix from the
(Code Page 1252) on page A-4
• You can string together several entries for several symbologies at
one time.
• Enter prefixes and suffixes in the order in which you want them to
appear on the output.

To Add a Prefix or Suffix:

Step 1.
Scan the Add Prefix or Add Suffix symbol
Step 2.
Determine the 2 digit Hex value from the Symbology Chart (included
in "Symbology Chart"
want to apply the prefix or suffix. For example, for Code 128, Code ID
is "j" and Hex ID is "6A".
Step 3.
Scan the 2 hex digits from the
manual or scan 9, 9 for all symbologies.
Step 4.
Determine the hex value from the
Page 1252) on page
Step 5.
Scan the 2 digit hex value from the
of this manual.
Step 6.
Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7.
To add the Code I.D., scan
To add AIM I.D., scan
To add a backslash (\), scan
NOTE
Step 8.
Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Example: Add a Suffix to a specific symbology
To send a CR (carriage return)Suffix for UPC only:
4-2
, plus Code I.D. and AIM I.D.
on page A-1) for the symbology to which you
Programming Chart on page B-5
A-4, for the prefix or suffix you wish to enter.
5 C
,
5 C 8
, , ,
5
To add a backslash (\) as in Step 7, you must
scan 5C twice – once to create the leading back-
slash and then to create the backslash itself.
ASCII Conversion Chart
(page
ASCII Conversion Chart (Code
Programming Chart on page B-5
8 0
, , .
1
.
C 5 C
, , , .
DuraLine™ 2D Imagers
4-4).
of this