Table of Contents
Advertisement
bols that represent the command you want to enter. 94 alphanumeric
characters may be entered for each symbology data format.
Step 7.
Scan Save from the
to save your entries.
Other Programming Selections
Clear One Data Format —
bology. If you are clearing the primary format, scan 0 from the
ming Chart on page B-5
format, scan 1, 2, or 3, depending on the alternate format you are clear-
ing. Scan the Terminal Type and Code I.D. (see
), and the bar code data length for the specific data format that
page 2-2
you want to delete. All other formats remain unaffected.
Save—
from the
exits, saving any Data Format changes.
Discard—
from the
exits without saving any Data Format changes.
Data Format Editor Commands
Send Commands
F1 Send all characters followed by "xx" key or function code, starting from
current cursor position. Syntax = F1xx (xx stands for the hex value for
an ASCII code, see
page
A-4.)
F2 Send "nn" characters followed by "xx" key or function code, starting from
current cursor position. Syntax = F2nnxx (nn stands for the numeric
value (00-99) for the number of characters and xx stands for the hex
value for an ASCII code. See
on page
A-4.)
F3 Send up to but not including "ss" character (Search and Send) starting
from current cursor position, leaving cursor pointing to "ss" character fol-
lowed by "xx" key or function code. Syntax = F3ssxx (ss and xx both
stand for the hex values for ASCII codes, see
(Code Page 1252) on page
F4 Send "xx" character "nn" times (Insert) leaving cursor in current cursor
position. Syntax = F4xxnn (xx stands for the hex value for an ASCII
code, see
ASCII Conversion Chart (Code Page 1252) on page
nn is the numeric value (00-99) for the number of times it should be sent.)
E9 Send all but the last "nn" characters, starting from the current cursor posi-
tion. Syntax = E9nn (nn is the numeric value (00-99) for the number of
characters that will not be sent at the end of the message.)
Product Reference Guide
Programming Chart on page B-5
This deletes one data format for one sym-
of this manual. If you are clearing an alternate
Programming Chart on page B-5
Programming Chart on page B-5
ASCII Conversion Chart (Code Page 1252) on
ASCII Conversion Chart (Code Page 1252)
A-4.)
Data Format Editor Introduction
Supported Terminals on
of this manual. This
ASCII Conversion Chart
of this manual
Program-
of this manual. This
A-4, and
5-3
Advertisement
Table of Contents
