Wasp WWS800 User Manual page 8

' - " -
The scanner can work offline and store data in the internal Flash memory for later
upload to the host. The stored data can be up to 32Kbytes.
' - " '
This setting enables or disables the memory function of the scanner.
*
The CLEAR label will enable the user to CLEAR or ERASE the data in the
scanner's memory. The user must also scan the CONFIRM label immediately after
the CLEAR label.
*
This enables the user to transmit the data in the scanner's memory to the host. The
interface selected by the user will be used for the transmission. During the
transmission, the red LED of the scanner will be flashing.
' - " * * "
This will enable the user to set a delay between each data records in memory at time
of transmission.
#
The WWS800 can be configured to use a standard Bluetooth Serial Port as the data
output interface. This allows the WWS800 to send the scanned bar code data to a
Bluetooth enabled computer or mobile device directly without the need of the
WS800 base unit (however, a charging dock is still needed for recharging the
scanner's battery).
In this section, a step-by-step procedure for installing and configuring the WWS800
for a Bluetooth Serial Port configuration is illustrated. Bluetooth
transceivers/dongles come with their own hardware driver. Bluetooth device
drivers for Windows and WinCE/Pocket PC are available from the Bluetooth
transceiver/dongle manufacturer. In the following example, a WIDCOMM driver is
used.
# $ ! !
Before starting the configuration, the scanner must be powered up. If you have not
done so, please follow the procedures described in section 2.2 "Power Up the
WWS800 Cordless Scanner" to power up the scanner.
The first step of the configuration is to put the scanner in configuration mode. To
do this, scan the "Enter Setup" bar code in the Reference Guide. After the device is
configured, scan the "Update" bar code to save the new settings and put the scanner
back to normal operation mode.
# ( 2
Scan the "Activate Bluetooth Serial Port" bar code in the Reference Guide to
change the interface type to Bluetooth Serial Port.
# ( : 1
Connection authentication is available if communication security is desired. Once
this setting is enabled, a user configurable PIN code is verified during connection
establishment. The scanner will refuse connection if the PIN code is incorrect. Up
to six characters can be specified for a PIN code.
# * 2 1 - !
The scanner can be configured to hide itself by NOT broadcasting itself on the air.
This can prevent an unwanted connection to a Bluetooth enabled computer or
mobile device. For the initial connection setup, this setting must be enabled.
$