Table of Contents
Advertisement
Removal & Installation
REMOVAL
1. Lift cover (E, figure 1) off bag assembly (D). Clips
on underside of cover will unlock from bag frame
as you lift.
2. Lift bag assembly (D) off hanger, folding bag back
as needed to clear grass discharge tube (A).
Figure 1. Install Bag & Cover
A. Grass Discharge Tube
D. Bag Assembly
B. Hanger Tubes
E- Cover
C. Bag Tubes
3. Remove spring clip (C, figure 2).
4. Lift hanger (D) off tractor. Then reinstall spring
clip (C) in hole of pin (B) at bottom of hanger.
5. Slide grass discharge tube (E) up and off grass
catcher adaptor (F).
6. Remove nuts, lockwashers and flat washers (B
through G, figure 3). Then remove grass catcher
adaptor (H) from mower.
7. To prevent loss, reinstall nut, lockwasher and flat
washer {E, F and G).
Figure 2. Install Hanger & Discharge Tube
A. Spacers {both sides)
D. Hanger
B. Pin
E. Grass Discharge Tube
C. Spring Clip
F. Grass Catcher Adaptor
8. If mower is to be used without grass catcher,
install original mower deflector (A) onto mower
using flat washers, lockwashers and nuts (B, C and
D).
Figure 3. Install Grass Catcher Adpator
A. Mower Deflector
E. Nut
B. Nut
F. Lockwasher
C. Lockwasher
G. Flat Washer
D. Flat Washer
H. Grass Catcher Adaptor
4
Advertisement
Table of Contents
