Snapper 1690229 Operator's Manual page 12

Setup Instructions
A. Carriage Bolt, 3/8 x 3/4
B. Discharge Baffle
C. Carriage Bolt, 3/8 x 3/4
D. Flat Washer, 1 /4
E. Lockwasher, 5/16
F. Nut, 5/16
G. Mower Blade
H. Grass Catcher Blade
I. Carriage Bolt, 5/16 x 3/4
J. Self-Tapping Screw, 5/16 x 1/2
K. Mower Blade, Discharge Side
L. Nut, 3/8
M. Lockwasher, 3/8
N. Flat Washer, 3/8
O. Pushnut
8. Remove discharge deflector (B, figure lO) from
mower. The deflector is held in place by two
carriage bolts, lockwashers and nuts (A, C and D).
9. Install two carriage bolts removed in step 8
upward through holes in mower. Place a pushnut
on the end of each bolt. Use a box wrench to push
the nut fully down on the bolt threads so it holds
the bolts to the mower as shown in figure 10.
Figure 10. Remove Discharge Deflector
A. Carriage Bolts D. Nuts
B. Mower Deflector E. Pushnuts
C. Lockwashers
10