Floor Pan Removal & Installation - Snapper 5900769 Operator's Manual

Regular Maintenance
Deck Leveling Adjustment
NOTE: Before adjusting the deck level, the deck lift
rod timing must be checked and/or adjusted.
1. Park the machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar); front
tires to 40 psi (2,76 bar).
2. Lock the deck lift pedal in the 4-1/2" (11,47 cm)
position. Place the deck height adjustment pin in the
4" position and lower the deck lift pedal until the arm
contacts the pin.
36" Models & 48" Flat Nosed Models:
3. Place 2 x 4 blocks under each corner of the mower deck
with the 3-1/2" sides being vertical. Place a 1/4" (0,64
cm) thick spacer on top of the rear 2 x 4 blocks. See
Figure 38.
4. 36" Models: Loosen the nut on the eyebolt until the
chains are tight and the front of the deck is still resting
the on the 2 x 4's.
48" Models: Adjust the front eyebolts until the chains
are tight and the deck is still resting on the 2 x 4's.
Tighten the jam nuts. See Figure 39.
5. Loosen the nuts and allow the rear of the deck to rest on
the 2 x 4's and 1/4" spacers. Slide the chains down in
the slots until the chains are tight and tighten the nuts.
See Figure 39.
6. Remove all 2 x 4 blocks and spacers from under the
mower deck.
48" iCD Models:
3. Place 2 x 4 blocks under each corner of the mower deck
with the 3-1/2" side being vertical. See Figure 38.
4. Adjust the front eyebolts until the chains are tight and
the deck is still resting on the 2 x 4's. Tighten the jam
nuts. See Figure 39.
5. Loosen the nuts and allow the rear of the deck to rest on
the 2 x 4's. Slide the chains down in the slots until the
chains are tight and tighten the nuts. See Figure 39.
6. Remove all 2 x 4 blocks from under the mower deck.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan
which can be removed to provide better access to the
mower deck.
1. Loosen and remove the knob (A, Figure 40) that
secures the floor pan (B) to the frame of the unit.
2. Tilt the back end of the floor pan up and then
remove it from the unit.
3. To re-install the floor pan: Reverse the removal
procedure.
32
Figure 39. Hanger Chain Adjustment
Figure 40. Floor Pan Removal & Installation
36" Models
48" Models
A
B
www.SnapperPro.com