Transmission Identification; Transmission Maintenance; Hood Removal And Installation - Snapper LT-200 Series Operator's Manual

Transmission Identification

To determine what transmission is in your tractor, check
the identification tag attached to the axle of the transmis-
sion (Figure 11), or check your tractor's illustrated parts
list.

Transmission Maintenance

K46 Maintenance
The K46 is a sealed unit and does not require regular
maintenance. If the transmission lacks drive or is exces-
sively noisy, it may need to be purged. See
"Transmission Purging" in the TROUBLESHOOTING,
ADJUSTMENTS, & SERVICE section.

Hood Removal and Installation

HOOD REMOVAL
1. Open the hood.
2. Remove the socket and bulbs (A, Figure 12) by twist-
ing the socket counterclockwise and pulling it out of
the bezel (B). Repeat on other side.
3. Rock the hood back slightly and lift hood (B, Figure
13) off pivot posts (C). Set hood on a clean and flat
surface.
HOOD INSTALLATION
1. Set hinge posts (A, Figure 13) onto pivot posts (C).
2. Roll the hood forward until it reaches the stops (D).
3. Install the socket and bulb (A) by pushing it into the
bezel (B) twisting the socket and bulb clockwise.
Repeat on other side.
4. Close the hood.
Figure 11. Transmission ID Tag Location
A. ID Tag
B
Figure 12. Head Light
A. Socket and Bulb
B. Bezel
B
D
A
Figure 13. Hood Removal and Installation
A. Hinge Post
B. Hood
C. Pivot Post
D. Stop
21
Regular Maintenance
TUFF TORQ K46Z
10010101 10010101010
A
A
A
C