Electronic Fuel Injection (Efi) System - Fuel Injected Models; Cleaning The Battery And Cables; Floor Pan Removal & Installation (S/N: 2016518420 & Above) - Snapper PRO S200XT Operator's Manual

Maintenance
Electronic Fuel Injection (EFI) System -
Fuel Injected Models
EFI is an electronically-controlled fuel management
system which is monitored by an Electronic Control
Unit (ECU). A Malfunction Indicator Lamp (M.I.L.) will
illuminate if problems or faults are detected. Servicing
by an authorized dealer is necessary.

Cleaning the Battery and Cables

NOTE: This unit is equipped with a maintenance-free
BCIU1 battery.
WARNING
Be careful when handling the battery. Avoid
spilling electrolyte. Keep flames and sparks
away from the battery.
When removing or installing battery cables,
disconnect the negative cable FIRST and
reconnect it LAST. If not done in this order, the
positive terminal can be shorted to the frame by
a tool.
1. Disconnect the cables from the battery, negative
(black) cable first (B, Figure 53).
2. Clean the battery terminals and cable ends with a
wire brush until shiny.
3. Reinstall the battery and reattach the battery
cables, positive (red) cable first (A).
4. Coat the cable ends and battery terminals with
petroleum jelly or non-conducting grease.
Floor Pan Removal & Installation (S/N:
2016518420 & Above)
This unit is equipped with a removable floor pan which
can be removed to provide better access to the mower
deck.
1. Loosen and remove the retaining hardware (A,
Figure 54) that secures the floor pan to the frame of
the unit.
2. Tilt the back end of the floor pan up and then
remove it from the unit.
3. To re-install the floor pan: Reverse the removal
procedure.
44
CAUTION
Do not disconnect or reconnect ECU
wiring harness connector or any individual
components with the ignition switch in the
"ON" position. This can send a damaging
voltage spike through the ECU.
Unplug harness from ECU before performing
any welding on equipment.
B
Figure 53. Battery Compartment
A. Positive (+) Cable & Terminal
B. Negative (-) Cable & Terminal
Figure 54. Floor Pan Removal & Installation
A
A
B
www.SnapperPro.com