Recording To Mds; Recording To An Md - Sony MDS-JB940 Operating Instruction

Recording to
MDs
'This chapter explains the various ways
to record to an MD, as well as how to
mark track numbers and perform
synchro-recording with other
components. See also "System
limitations" on page 51 before
recording.
98 14 | Recording to an MD:
Recording to an MD
If the MD has been partially recorded, recording starts
after the recorded tracks.
ve slot INPUT REC
> n
1 Turn on the amplifier and program source,
'select the source on the amplifier.
2 Press 1/(!) to turn on the deck.
'The STANDBY indicator turns off
3 insert a recordable MD into the slot.
4 Press INPUT repeatedly to select the input jacks.
(connector) connected to the program source.
When the source is connected to
the
DIGITAL OPTICAL INT ©
DIGITAL OPTICAL IN? connector [OPT2
Set INPUT to
orn
DIGITAL COAXIAL IN jack COAX
ANALOG jacks
ANALOG
5 It necessary, locate the point on the MD to start
recording from.
If you want to record to a new MD or start recording
from the end of the recorded portion, skip this step and
g0 10 step 6.
'To record over from the beginning of an exis
MD track
Tum AMS (or press K/P repeatedly) until the
number of the track to be recorded over appears
To record over from the middle of an MD track
Tum AMS (or press Kd PPA repeatedly) until the
number of the track to be recorded over appears, then
press > to start play. Press B at the point you want to
start recording from.
6 Press REC €.
The deck changes to recording pause.
7 if necessary, adjust the recording level.
For details, see "Adjusting the recording level" on
page 17.
8 Press > or tI.
Recording starts.
9 Start playing the program source.