Answering System Settings; Answering System Set Up; Number Of Rings; Remote Code - VTech CS6228-3 User Manual

Answering system settings

Answering system set up

Use a system handset to change your answering system settings.

Number of rings

You can choose from two, four, or six rings; or toll saver. With toll saver
selected, the answering system answers after two rings when you have new
messages, and after four rings when you have no new messages. This enables
you to check for new messages and avoid paying unnecessary long distance
charges if you are calling from out of your local area.
Press MENU/SELECT to show the menu when the handset is not in use.
1.
Press MENU/SELECT to select > ANS. SYSTEM.
2.
3. Press or
4. Press or
5. Press or
MENU/SELECT to confirm your selection.

Remote code

A two-digit security code is required to access the answering system remotely
from any touch tone telephone. The preset code is 19. You can set the code
from 10 to 99.
Press MENU/SELECT to show the menu when the handset is not in use.
1.
Press MENU/SELECT to select > ANS. SYSTEM.
2.
3. Press or
4. Press or
5. Press or

Message alert tone

This telephone can beep every 10 seconds to alert you of new messages. The
tone stops when all new messages have been reviewed.
Press MENU/SELECT to show the menu when the handset is not in use.
1.
Press MENU/SELECT to select > ANS. SYSTEM.
2.
3. Press or
4. Press or
5. Press or
confirm your selection.
The answering system must be turned on for the message alert tone to
function.
to select > ANS SYS SETUP, then press MENU/SELECT.
to select > #
OF RINGS, then press MENU/SELECT.
to choose from 2, 4, 6 or TOLL SAVER, then press
to select > ANS SYS SETUP, then press MENU/SELECT.
to select > REMOTE CODE, then press MENU/SELECT.
to select, then press MENU/SELECT to confirm.
to select > ANS SYS SETUP, then press MENU/SELECT.
to select > MSG ALERT TONE, then press MENU/SELECT.
to select from ON or OFF, then press MENU/SELECT to
11