Quick start guide
for models CS6228-3/CS6228-5/
CS6228-6/CS6229/CS6229-2/CS6229-3/
CS6229-4/CS6229-5
Install the telephone base and
charger(s)
Install the telephone base and charger(s) as
shown below.
Telephone
Telephone
base power
wall jack
adapter
Charger adapter
If you have DSL
high speed Internet
service, a DSL
filter (not included)
is required.
Electrical outlet
not controlled by
Telephone
a wall switch
line cord
Charger
Telephone base
1.
Use only the power adapter(s) and
battery(ies) supplied with your VTech
telephone.
2.
For complete feature instructions, please
refer to your user's manual.
Battery installation and charging
Install the battery as shown below. After
installing the battery, you might be able to make
and receive short calls. For best performance,
charge the handset battery for at least 16 hours
before use.
1
2
Plug the battery securely
If the battery
into the plug inside
compartment cover is on
the handset, press the
the handset battery
compartment, matching
indentation and slide the
the color-coded label.
cover to remove.
4
3
Place the battery with
Align the cover flat
the label THIS SIDE
against the battery
UP facing up and the
compartment, then slide
wires inside the battery
it towards the center of
compartment.
the handset until it clicks
into place.
5
Charge the handset by
CHARGE light
placing it in the telephone
base or charger. The
CHARGE light is on when
the handset charges.
Make, answer and end a call
Make a call
/FLASH or
1.
Press
.
You hear a dial tone.
2.
Dial the number.
Make a predial call
1.
Dial the number.
2.
Press
or
.
/FLASH
Answer a call
Press
,
or any
/FLASH
of the dialing keys (
-
,
).
0
9
#, *
End a call
Press OFF/CLEAR or put the handset in the
telephone base or charger.
Turn the answering system
on or off
The answering system must be turned on to
answer and record messages.
When the answering system is turned on, the
light on the telephone base will be
ANS ON/OFF
on and
will display on the handset.
ANS ON
To turn on or off with
the telephone base:
•
Press ANS ON/OFF
to turn the answering
system on or off. If the
answering system is
turned on, it announces,
"Calls will be answered."
If the answering system is
turned off, it announces,
"Calls will not be answered."
To turn on or off with a handset:
1.
Press MENU/SELECT to show the menu
when the handset is not in use.
2.
Press MENU/SELECT to select
> ANS. SYSTEM.
to select > ANS SYS SETUP,
3.
Press
or
then press MENU/SELECT.
Press MENU/SELECT to select
4.
> ANSWER ON/OFF.
to choose ON or OFF, then
5.
Press
or
press MENU/SELECT.