Table of Contents
Advertisement
3. To bring the input arm assembly and detent arm assembly closer or bring the detent arm assembly towards the rear of the
machine:
a. Lean the input arm assembly towards the front of the machine.
b. Remove screws and washers securing the bumper to the base frame assembly using a Torx screwdriver.
c. Remove shim from under the rear bumper.
4. To increase the gap between the input arm assembly and detent arm assembly or bring the detent arm assembly towards the
front of the machine:
a. Install additional shim under the rear bumper.
Item
1
2
3
Item
1
2
Page 26 of 38
Description
Screw, 10-32, TRX
Washer, M6
Bumper
Description
Shim
Bumper
Qty.
4
4
1
Qty.
TBD
1
Advertisement
Table of Contents
